Windhoist Liebherr put straight to work

Premium Content

17 April 2009

Liebherr LTM 11200-9.1 Windhoist McNally at work on its first job near Nuremberg, Germany

Liebherr LTM 11200-9.1 Windhoist McNally at work on its first job near Nuremberg, Germany

Irish company McNally - Windhoist collected its new Liebherr LTM 11200-9.1 telescopic wheeled mobile crane from the factory in Ehingen, Germany and drove it straight to a job near Nuremburg.

The project at Heidenheim was to erect an Enercon E-70 wind turbine so the crane was erected in a typical wind power configuration of 100 m telescopic boom with Y-suspension, 16 m lattice extension and hydraulically adjustable 6.5 m assembly jib.

Following installation of 98 m tower's top section, the machinery house and the 55 tonne generator were mounted. The 70 m diameter rotor weighing 50 tonnes was preassembled at ground level before the LTM 11200-9.1 lifted it to a sheave height of 115 m to attach it to the hub.

Liebherr said that the LTM 11200-9.1 design is optimised for erecting wind turbines up to 3 MW. Erection times are shorter than with lattice boom cranes and less counterweight is necessary, Liebherr said.

WorkDry invests in pump fleet in preparation for extreme events
Company adds hundreds of new pumps in anticipation of extreme El Niño weather events.
Chinese gains reshape South American market
Chinese construction equipment manufacturers are becoming an established competitive force in South America rather than simply a low-cost alternative, according to a white paper from Off-Highway Research
Smarter by design: How intelligent excavators are delivering better jobsite results
Integrated technology is helping contractors improve accuracy, productivity and control without neglecting the fundamentals of machine performance