EWPA anchorage guidance

By Euan Youdale31 July 2018



The Elevating Work Platform Association of Australia (EWPA) has produced a guidance note regarding harness anchorage points on MEWPs.

The recommendations were put together by EWPA’s Technical comittee and apply to the inspection and testing of the harness anchorage points.


All boom type MEWPS are fitted with fall arrest anchorage points in accordance with AS/NZS1418.10 and have an ultimate capacity of 15kN for one person or 21kN for anchorages designed for two people.

Other MEWPs may be fitted with fall arrest or fall restraint anchorages. Restraint anchorages have a minimum capacity of 6kN per person.

Anchorages are type tested and form an integral part of the MEWP. As anchorages are designed and fitted by the MEWP manufacturer, the name of the installer or certifier is on the ID plate for the MEWP.

Note: Anchorage points are for attachment of fall arrest/restraint hardware only. They are not intended as tie downs or lifting points.


AS/NZS1418.10-2011 (+A1) specifies the following:

  • The location of anchorages shall be marked;
  • Fall arrest anchorages shall be marked to indicate the number of persons that can be attached. Their capacity shall not be shown.
  • Fall restraint anchorages shall be located no more than 750mm above the floor and marked “Restraint Only” and shall indicate the number of persons that can be attached.

Because the capacity of the anchorage is greater than the MEWP the capacity of the anchorage (in terms of force) is not shown. The capacity of the anchorage is expressed in terms of the number of persons that can be attached.

Inspection and maintenance 

The following inspections are recommended at every routine inspection:

  • Visual Inspection of the anchorage and adjacent structure for damage, corrosion, cracking, distortion and excessive wear.
  • Decals installed and legible.
  • Any anchorage that has experienced a fall arrest should be inspected and follow manufacturer’s instructions for replacement.

Because inspection of the anchorages forms part of the routine inspection requirements the record of inspection is completed in the logbook and tagging of individual anchorages is not required or recommended as tags can interfere with the proper use of the anchorage.

Testing of anchorages

Load testing of anchorage points is not recommended because testing can compromise the integrity of the anchor point or the structure it is attached to.




Latest News
Lift-All expands with Grove truck cranes
The Omaha, Nebraska-based lifting provider recently added two new Grove truck cranes to its fleet.
‘Once in a lifetime’ moment for US infrastructure
Pete Buttigieg, US Secretary of Transportation, says low interest rates and high unemployment have created a generational opportunity to invest in infrastructure
Doosan to show XiteCloud tech at Hillhead Digital
Doosan Infracore’s new XiteCloud quarrying, mining and construction platform will be presented to the UK for the first time at this year’s online event